LASER DSP-AP with MCS, is a full security system, managed through a Security Control Module. This module not only controls the front security managed by the DSP laser, but also manages all the standard devices that the press brake needs for its operation.

The solenoid valves that control the hydraulics of the machine, the lateral protections, the back protection, the emergency stops, the pedals of descent and rise and more; its are all the components controlled by the MCS.

To equip a new press brake with MCS and DSP LASER AP, is to have a machine with safe, advanced technology.

Integrating the MCS and DSP LASER AP system into a used machine is very easy; With this update, a lot of space is gained in the electrical maneuver and a complete adaptation to the current regulations is achieved. This is a high-end system, which comes from the DSP LASER, a well-known and proven economic system.

This system harmonizes compliance with current regulations, ease of installation and use, as well as the speed of the bending cycle with a safe stop just 2mm from the sheet. It is a robust system, with an unbeatable relationship in Quality, Performance and Cost.

This laser safety system with sophisticated electronic circuit is in compliance with the Machine Directive 2006/42 / CE and the harmonized standard, specific for the Safety of machine tools, Hydraulic Presses Press brakes EN 12622: 2009 + A1: 2013 as well as with EN 61496-112, guaranteeing the safety of the operator, without obstructing the bending cycle.

The DSP LASER AP system with MCS, is a solution designed specifically for press brakes, and is the result of more than 30 years of experience in the field of machine tool safety, especially in press brakes.